Refurbished Cumberland 3250 Granulator

Refurbished Cumberland 3250 GranulatorCumberland equipment has a long history of success in the recycling industry. We recently completed rebuilding this machine from top to bottom. The machine has had every bolt hole repaired not with just Heli-coils but we have drilled each of these holes out oversize and used 4140 inserts to make a more permanent repair. All wear surfaces have been rebuilt using Stoody hard-facing build up wire for long lasting ability to these high wear areas. New bearings were installed on the refurbished rotor along with new fly knives. All the bed knives surfaces were repaired and new bed knives installed. This machine was used previously to take 2 inch tire chips down to a ¾ inch chip at a rate of about 2 tons per hour. It is powered by a 250 hp electric motor, and the rotor will be completely rebuilt. Machine comes with in-feed and out-feed hoppers and is ready to be put into operation. This machine would work well in the rubber industry or would have very high capacities in the plastic recycling industries. The unit has water jackets around the cutting chamber as well as through the center of the rotor. This machine will come with a new set of screens, size of your choice. Refurbished Cumberland 3250 GranulatorRefurbished Cumberland 3250 Granulator